Request a Quote

Home / Products / Push-On Hose Fittings / Brass Hose Fitting Hose Splicer1

Brass Hose Fitting Hose Splicer1 — representative product photo, full product on white background
Push-On

Brass Hose Fitting Hose Splicer1

296(拟配) · Brass / composite programme · Brass push-on programme · for push-on (no-clamp) hose.

This is a representative photo of the series/type — it does not show a specific size. The specification for this product is in the table on this page.

About this fitting

Brass Hose Fitting Hose Splicer1 is a splicer (hose mender) in WAVE's Push-On family. It joins two hose ends in a straight line, so a damaged hose section can be cut out and the line restored without replacing the whole hose. The barb profile is matched to push-on hose, so the hose pushes on and holds by design — no clamp and no ferrule. It is threadless — its ends take Hose I.D. 1/4″ – 3/4″ hose directly, with no thread anywhere on the part. Family working range: By hose used — confirmed at inquiry, By hose used — confirmed at inquiry. The exact variant is picked from the size options on this page and confirmed against the factory catalogue at inquiry.

Select a size

Inquire on this modelCross-reference a number
Specification — Brass Hose Fitting Hose Splicer1
Model296(拟配)
MaterialBrass or stainless steel (page states both; not specified per variant)
Reference Part No.BPM - 696 - 29SPO - 915 - 100B-Y - KA-RM - 296 - 729 - 38282
Working pressureLimited by hose l.D

Dimensions are reference data — please confirm at inquiry.

Size table — Brass Hose Fitting Hose Splicer1

PART#HOSE I.DL
296-41/41.87
296-55/161.80
296-63/82.00
296-81/22.01
296-105/83.03
296-123/43.03
296-161"3.21

Dimensions are reference data — please confirm at inquiry.

Features
  • Barbs at both ends join two hose ends in a straight line
  • Ends: Hose barb end × Hose barb end — threadless: no thread anywhere on this part
  • The barb profile is matched to push-on hose, so the hose pushes on and holds by design — no clamp and no ferrule.
  • No clamp or ferrule needed
  • This page covers Brass Hose Fitting Hose Splicer1 (296(拟配)) — select its size above and that exact variant is carried into the inquiry
Applications

Brass Hose Fitting Hose Splicer1 — It joins two hose ends in a straight line, so a damaged hose section can be cut out and the line restored without replacing the whole hose. In WAVE's Push-On family it serves: Low-pressure push-on hose lines · air and fluid transfer in workshop and fleet service.

Compatible tubing

For Brass Hose Fitting Hose Splicer1, the compatible line is: Push-on (no-clamp) hose, 1/4″–3/4″ I.D.. Every end of this splicer (hose mender) takes that line directly (Hose I.D. 1/4″ – 3/4″) — there is no threaded port in the joint.

The size options at the top of this page list only the sizes this configuration is made in — this configuration is threadless, so no thread sizes are listed for it.

Reference Part No.: buying this fitting under another brand’s number today? Search the cross-reference — confirmed mappings are labelled; anything unconfirmed is checked against the factory catalogue at inquiry, never guessed.

Related products — same family

← Back to Push-On Hose Fittings